If you are not using a Fusion source
for the data warehouse, you must disable Fusion steps in the Data Lineage ETL.
This step is applicable only for non-Fusion sources. If you use Fusion as a
source, you can skip this step.
To disable Fusion steps:
- In ODI Designer's tree view, navigate to the Load Plans
and Scenarios view and open the Data Lineage Extract and Load load plan
under Predefined Load Plans > Data Lineage.
- In the Steps tab, in the Steps Hierarchy, expand DATA
LINEAGE > Dimension_ETL.
- Deselect the Enabled check box for the Fusion step
(step 28) to disable the step.
- Expand DATA LINEAGE > Fact_ETL in the hierarchy and
disable the Fusion step (step 52).
- Expand DATA_LINEAGE > Dimension_ETL > OBIEE, and
enable the SDE_DL_OBIEE_BMM_HIERARCHY step (step 3).
No comments:
Post a Comment